Chad, head question

Tech Related Discussion

Chad, head question

Postby jmarkaudio » Sun Dec 15, 2013 7:10 pm

My brother has a 421 with Pontiac 867 heads. The heads are raised runner with 2.10/1.60, standard valve location, standard exhaust ports, and uses non offset stud rockers. Is there an inexpensive replacement casting available he could use? He would prefer to use the raised runner Bowtie intake if possible. If not, what are the largest port import castings available? The heads are old, have a bunch of epoxy, and the plan is to run E85 so epoxy is out.
Mark Whitener

Good work isn't cheap, and cheap work can't be good.
Posts: 605
Joined: Thu Nov 29, 2007 9:58 pm
Location: Florida

Re: Chad, head question

Postby Chad Speier » Tue Dec 24, 2013 9:40 am

I haven't found one.

I did trade for a set of smaller Edelbrock RR castings with a 2.150 valve.

Need a little repair work, but will be priced right!
Chad Speier
Chad Speier
Posts: 1846
Joined: Mon Nov 12, 2007 6:03 pm
Location: Hays, Kansas

Return to General Talk

Who is online

Users browsing this forum: No registered users and 1 guest