PC Hurricane Ported Manifold

Cylinder Head and Manifold Discussion

PC Hurricane Ported Manifold

Postby Chad Speier » Sun Nov 11, 2012 11:28 am

Image

Image

Image

Image
Chad Speier
Image
Chad Speier
 
Posts: 1846
Joined: Mon Nov 12, 2007 6:03 pm
Location: Hays, Kansas

Re: PC Hurricane Ported Manifold

Postby boneil » Sun Nov 11, 2012 5:57 pm

I don't know how well that manifold flows, but the casting does not look that good. It looks as if one of the runners where it connects to the floor is too thin. Is this a casting issue or by design?
boneil
 
Posts: 9
Joined: Mon May 07, 2012 5:01 pm

Re: PC Hurricane Ported Manifold

Postby coulterracn » Sun Nov 11, 2012 8:19 pm

boneil wrote:I don't know how well that manifold flows, but the casting does not look that good. It looks as if one of the runners where it connects to the floor is too thin. Is this a casting issue or by design?


I ported a different PC manifold that had the same issue. It's not as thin as it looks, it's just the leading edge where it meets the floor. No cause for alarm.

Ray
coulterracn
 
Posts: 6
Joined: Sun May 09, 2010 12:21 am
Location: Mississippi Gulf Coast

Re: PC Hurricane Ported Manifold

Postby Chad Speier » Sat Dec 08, 2012 9:08 am

Agree with ^^^. I also might have caught it with a burr! :D
Chad Speier
Image
Chad Speier
 
Posts: 1846
Joined: Mon Nov 12, 2007 6:03 pm
Location: Hays, Kansas


Return to Induction Talk

Who is online

Users browsing this forum: No registered users and 1 guest

cron